Dry Verge Systems Dublin

We remove failing verge mortar and fit interlocking caps that hold down the edge tiles on your gables.

Call 01 263 5253Get a FREE Quote

Free, no-obligation quote

Get a FREE Quote

Tell us about the roof and we will call you back to arrange a visit.

Free QuotesWritten, no obligation
24/7, 365 daysEmergency call-outs
Since 2018Sandyford, Dublin 18
Fully insuredPublic liability cover

Dry Verge

Why Mortar Verges Crack & Fall

A verge is where the tiles run out along the sloping edge above a gable wall. Traditionally, the last tile in each course sat on a strip of undercloak and was pointed in with a bead of mortar. That mortar takes the full force of wind-driven rain on an exposed edge, and it is usually the first part of a roof to fail.

Once it cracks, water gets behind it, frost pushes it apart and chunks start landing on the path, the car or the conservatory below. Worse, the verge tiles were often held by little more than that mortar, so a strong gust can lift them clean off.

01 263 5253 Get a FREE Quote

What’s Included

Signs Your Verge Needs Attention

You can usually spot verge trouble from the ground. If you notice any of these, the edge of your roof is overdue a closer look.

Gaps between the mortar and the tiles
Lumps of mortar under the gable
Verge tiles sitting higher than the rest
Staining on the gable wall below the edge
Missing or broken end tiles
Moss or weeds growing from the joint
Damp on an upstairs gable wall
Bare undercloak visible from the road

01 263 5253 Get a FREE Quote

How a Dry Verge System Works

A dry verge replaces the mortar bead with a run of rigid plastic caps that overlap one another down the gable. Each cap hooks over the edge of a tile and is fixed through to the batten end, so the edge is held mechanically from eaves to ridge.

Interlocking Verge Caps

Each cap clips into the one below it, forming a continuous weatherproof edge. Rain running along the verge is guided back onto the roof rather than soaking the gable wall, and there are no joints for frost to prise open.

Fixed to the Batten Ends

We fix every cap through to the batten end with a screw or nail, so the edge tile cannot rise. Where batten ends are short or rotten, we extend or replace them first, because the whole system depends on them.

Eaves Closure & Ridge End Cap

At the bottom, an eaves closure piece tidies the corner above the gutter and keeps birds out. At the top, a ridge end cap ties the verge into the ridge, so both lines finish cleanly with nothing left to point.

Unit or Continuous Systems

Some kits use an individual cap for each course of tiles, others a continuous section that runs the length of the gable. We choose the type that suits your tile profile and how exposed the gable is to the weather.

Swipe to see more

Reviews

What Our Customers Say

Rated Excellent on Trustindex. Every review is written by a customer, never by us.

Read Our Trustindex Reviews (opens in a new tab)Verify Trusted Reviews (opens in a new tab)

24/7, 365 Days a Year

You're in good hands

Storm damage, a leak through the ceiling or a slipped ridge tile: our phone is answered day and night, every day of the year.

FAQs

FAQs About Our Dry Verge Service

What homeowners usually want to know before we convert their gables to dry verge.

Can a dry verge be fitted without replacing the whole roof?

Yes. We only need to lift the tiles along the verge itself, so the rest of the roof is left alone. It is one of the most common jobs we carry out on houses where the roof is otherwise in decent shape but the gable mortar keeps breaking up.

What if my gable has a bargeboard?

Many houses have a timber or uPVC bargeboard along the gable. A dry verge can sit over it, and if the board is rotten we can replace it in uPVC at the same visit, so the edge looks finished and never needs painting again.

Will dry verge caps blow off in a storm?

Not when they are fitted correctly. Each cap is mechanically fixed to the batten and locked into the next, which is far stronger than a tile held only by a bead of mortar. The weak point is always rotten batten ends, which is why we check and renew them first.

Can you match the colour of my roof?

Verge caps come in a range of colours, including black, brown, grey and terracotta shades. We pick the one that sits best with your tiles, and on a semi-detached house we can match your neighbour's verge if theirs has already been converted.

Is a dry verge suitable for an older house?

On most concrete and clay tiled roofs, yes, whatever the age of the house. On natural slate and some period properties, a traditional mortar verge or a slate-specific dry system may look better, and we explain the options before you decide.

Ask Us Anything

Question About Your Roof?

Ring the office or message us on WhatsApp with a photo and you will get a straight answer.

Call, 24/701 263 5253
WhatsApp089 968 1613
Office
6 Fern Road, Sandyford, Dublin, D18 FP98

Why Choose Us

Why Choose Us for Your Dry Verge?

Verge work happens on the most exposed edge of the house, often right above a neighbour's driveway, so it needs care as much as speed.

Sandyford, Dublin 18

An Office You Can Find, a Phone That Gets Answered

Quotes, bookings and any follow-up are handled from our office on Fern Road in Sandyford, Dublin.

Batten Ends Checked

Rotten or short batten ends are the main reason dry verge caps fail, so we inspect and renew them before a single cap is fitted.

Clean, Tidy Sites

We sheet the ground below the gable, catch falling mortar as we work and leave your drive, path and gutters clear when we pack up.

Insurance in Place

We hold full public liability insurance, which matters when the work sits above a shared path, a neighbour's car or the public footpath.

Rated Excellent

Trustindex reviewers rate our work Excellent, and each dry verge we install carries our guarantee from the day it goes on.

Free Quotes, Written Down

Call or send the form with your Eircode and we will arrange a visit, look at the roof and price the work before anything starts.

01 263 5253 Get a FREE Quote

Swipe to see more

Irish Suppliers

Irish Names We Work With

Flat roof membranes, fibre cement and natural slate from Irish suppliers.

Professional Dry Verge

We convert gable ends to dry verge on houses and commercial buildings in Dublin, and over the border in Kildare, Meath, Wicklow and Louth. Weekday and weekend appointments are available, and if a verge tile has already come loose in a storm, our emergency roofers can make it safe 24/7.

Phone 01 263 5253 to arrange a free quote, or WhatsApp a photo of the gable to 089 968 1613.

Need a Dry Verge?

If mortar is dropping from your gable, call us for a free dry verge quote before the loose edge tiles go the same way.

01 263 5253 Get a FREE Quote

Our Work

Dry Verge Jobs We Have Finished

View the Gallery

How It Works

Fitting a Dry Verge to Your Gable

Most gables are converted within a day once access is in place, and you will not lose the use of any rooms while we work.

Step 01

Safe Access to the Edge

We set up a scaffold tower or a short run of scaffolding at the gable, because a verge cannot be worked on safely from a ladder alone.

Step 02

Strip the Old Pointing

The old mortar bead and any loose undercloak are broken out, and the verge tiles lifted so we can check the battens and felt underneath.

Step 03

Prepare the Batten Ends

Battens are trimmed or extended so they finish on the right line, and any rotten ends are cut back and replaced with treated timber.

Step 04

Fit Caps From Eaves to Ridge

Starting with the eaves closure, each cap is fixed and interlocked up the slope, finishing with the ridge end cap where the verge meets the ridge.

Swipe to see more

Get In Touch

Contact Our Roofers

Tell us where the property is and what you have noticed at the gable, and we will ring you to set up a free survey.

Call Us, Day or Night

01 263 525324 hours a day, 365 days a year

Send Us an Email

info@dublinroofingcompany.iePhotos of the problem help

Office: 6 Fern Road, Sandyford, Dublin, D18 FP98

Free Quote Request

Tell Us About the Job

Related Services

Local Roofers Dublin

6 Fern Road, Sandyford, Dublin. Covering Dublin, Kildare, Meath, Wicklow & Louth.